www.fancort.com/apress/assembly/options_5000L

Air Presses

Assembly Solutions

OPTIONS

Optional electrical timing circuit to control downward dwell time from 1 sec to 500 sec. The ram stroke position that activates the timer is also adjustable.
Part Number: BP-TM10, $895.
Optional Non-Rotating Ram, BPNR-1000, $350
Optional Non-Rotating Ram BPNR-500, $225
Optional Longer Stroke, BP-LS9 available up to 9" STD $642
Non-Contact electronic two-hand safety controls requires no pressure, just break a light beam and the press runs. OSHA approved. Simply insert fingers at the same time and the press will begin its cycle. Pull out either finger and the press will retract to the home position. 120 voltage. Note: Available for any Fancort Bench Air Press. Additional cost to any Fancort Press $535. P/N BP-SP/REN46.
Full View - - - Close Up
Optional end of stroke sensor is available for all Fancort presses. The system monitors the air flow to the lower side of the air cyclinder and when it senses no air movement it show the press has completed its work and stroke. Sensor turns red when cycle is complete. BPES-1 $200.
Green light indicates systems is ON
Red light indicates cycle complete
CALIBRATE YOUR OWN PRESS? See our new press output indicator
COMMERICAL DIE SETS
Heater Plates can be added to a customized press, air or servo
Case History: Servo Press with Heater Plates

Die Mounting Accessories
Part Number	Description
BPNR-500	Non-Rotating Ram, $225
BP-SC100	Round Collar for die shank mounting, 1.5" diameter x 1" deep, $133
BP-HC100	Horseshoe Collar for die mounting, $110
BP-HCT100	Standard "T" for use with horseshoe collar, $60

Build Your Own Press
Please print , fill out, and fax this form to us at 973-575-9234.