• Solid steel column with 11 " of height adjustment; longer columns are available
  
  
• 8" x 6" base with keyway for easy tool mounting
  
  
• OSHA approved two-hand safety controls, filter/regulator and speed control
  
  
• BP-500 Standard 3.25" bore cylinder, 725 lbs at 100 psi $1,895 with 3" stroke, double action cylinder
  
  
• BP-500-1 with 1" bore cyclinder, 5-50 lbs output, 5/16 24 therm, with 3" stroke, $2,095
  
  
• BP-500-4; optional 4" bore cylinder, 1175 lbs at 100 psi $2,095 with 3" stroke, double action cylinder
  
  
• Non-contact press activation requires no pressure, just break a light beam and the press runs. OSHA approved. Simply insert fingers at the same time and the press will begin its cycle, pull out either finger and the press will retract to the home position, 120 volt. Note: available for any fancort Bench Air Press. Additional cost to any Fancort Press $535. P/N BP-SP/REN 46
  
  
• Calibrate your press? See our new press output indicator.

Non-contact electronic two-hand safety controls
Full view
Close Up

• Optional stroke lengths available
  
  
• Optional end of stroke sensor is available for all Fancort presses. The system monitors the air flow to the lower side of the air cylinder and when it senses no air movement it shows the press has completed its work and stroke. Sensor turns red when the cycle is complete.BPES-1 $165.
• Green light indicates system is ON
• Red light indicates cycle complete
  
  
• Minimum press cycle is 2 second down and up using speed control
  
  
• Minimum operating pressure is 60 PSI input "Line Pressure," and the output force will be about 460 lbs standard
  
  
• Male rod threaded 3/4-16 x 1"
  
  
• Measures 16" x 10" x 23"
  
  
• Weighs 47 lbs.
  
  
• One-year warranty
  
  
• Optional electrical timing circuit to control downward dwell time from 1 sec to 500 hours. The ram stroke position that activates the timer is also adjustable. Part Number: BP-TM10, $895.
  
  
• Ram on cylinder is polished stainless steel
  
  
• Minimum cycle time 2 sec.
  
  
•  Optional Die Sets