• 10" x 12" bed area with 8" throat and centrally located ram
• Rigid 'C' frame with 1" thick side walls to prevent flexing and allow for robotic loading
• Attractive blue enamel finish and hardcoat aluminum die plate with three sets of tapped holes for die mounting
• 4" stroke, 7.25" shut height
• Optional stroke lengths available
• Filter/regulator, manual shut-off and speed control
• Minimum press cycle is 1 second down and up using speed control
• Dual-palm controls
• Optional upgrade including front cover with counter and pressure gauge (P/N BP-1000U)
• Measures 18" W x 10" D x 26" H
• Weighs 73 lbs.
• Non-Contact Press Activation requies no pressure, just break alight beam and the press runs. OSHA approved. Simply insert fingers at the same time and the press will begin its cycle. Pull out either finger and the press will retract to the hom eposition. 120 volt. Note: Available for any Fancort Bench Air Press.
• Optional electrical timing circuit to control downward dwell time from 1 sec to 500 hours. The ram stroke position that activates the timer is also adjustable. Part Number: BP-TM10, $895.
• One-year warranty
• Ram on cylinder is polished stainless steel
• Male rod threated 3/4-16 x 1" for 5" cyl., 1 1/4 x 1 1/2 for 6" cyl.
• Minimum cycle time 2 sec.
•  Optional Die Sets
• Optional end of stroke sensor is available for all Fancort presses. The system monitors the air flow to the lower side of the air cyclinder and when it senses no air movement it shows the press has completed its work and stroke. Sensor turns red when the cycle is complete.BPES-1 $150.
• Green light indicates system is ON
• Red light indicates cycle complete
  

Non-Contact electronic
two-hand safety controls

Full View
Close Up