Model 5000L $4,050
Datasheet
Press Output Comparison
Click for Press Options, Short Form Catalogue
Click for layout drawing
Click for Tonnage Calculations
Click for Shear Strengths of Various Metals
Compliant Pin Pressing

• 16" W x 13 1/4" D bed area with 6" throat. Wider model is available with 22" W bed
  
  
• OSHA approved two-hand safety controls
  
  
• EC approved. Certificate # EC95/00022
  
  
• Centrally located ram with 1.5" x 1" shank collar
  
  
• 4" stroke standard, 7.25" shut height to ram
  
  
• Optional stroke lengths available
  
  
• Double-acting 5" cylinder (1 ton at 100 psi), cushioned cap
  
  
• 6" cylinder (1.4 tons at 100 psi) optional
  
  
• Speed control, filter/regulator, dual palm anti-tie-down controls, counter and front mounted air gauge
  
  
• Minimum press cycle is 1 second down and up using speed control
  
  
• Controls, counter and front-mounted air gauge
  
  
• Measures 17" x 13.5" x 27"
  
  
• Weighs 100 pounds
  
  
• Non-Contact Press Activation requires no pressure, just break a light beam and the press runs. OSHA approved. Simply insert fingers at the same time and the press will begin its cycle. Pull out either finger and the press will retract to the home position. 120 voltage. Note: Available for any Fancort Bench Air Press. Additional cost to any Fancort Press $535. P/N BP-SP/REN46

  Non-Contact electronic two-hand safety controls
  Full View
  Close Up

• Calibrate your press? See our new press output indicator.
  
  
• Optional electrical timing circuit to control downward dwell time from 1 sec to 500 sec. The ram stroke position that activates the timer is also adjustable. Part Number: BP-TM10, $895.
  
  
• Optional Non-Rotating Ram, BPNR-1000, $350
  
  
• Optional Longer Stroke, BP-LS9 available up to 9" STD $642
  
  
• Ram on cylinder is polished stainless steel
  
  
• Male rod threated 3/4-16 x 1"
  
  
• Cycle time from 2 to 60 sec. depending on model
  
  
•  Optional Die Sets
  
  
• Optional end of stroke sensor is available for all Fancort presses. The system monitors the air flow to the lower side of the air cyclinder and when it senses no air movement it show the press has completed its work and stroke. Sensor turns red when the cycle is complete. BPES-1 $200.
  
  
• Green light indicates systems is ON
• Red light indicates cycle complete

• Air over hydraulic system with 4" stroke and .200 hydraulic power stroke 4.95 tons
  
  
• 16" W x 13 1/4" D bed area with 6" throat. Wider model is available with 22" W bed
  
  
• Centrally located ram with 1.5" x 1" shank collar
  
  
• 4" stroke standard, 7.25" shut height to ram
  
  
• Optional stroke lengths available
  
  
• Speed control, filter/regulator, dual palm anti-tie-down
  
  
• Press cycle time is 6 seconds
  
  
• Controls, counter and front-mounted air gauge
  
  
• Measures 17" x 13.5" x 45"
  
  
• Weighs 130 pounds
  
  
• Male rod threaded 3/4-16 x 1"
  
  
• Cycle time of 2-4 sec
  
  
• $11,505
  
  
•  Optional Die Sets